
Giá đỡ màn hình Carplay cho RAM thế hệ 4
- Downloads
- 1
- Likes
- 0
- Views
- 42
- Remixes
- 0
- Comments
- 0
Files 1 954.1 KB
- CarpodGo_T3_Pro_Mount_1783848027.stlSTL · 954.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #410608
- Category
- DIY
- Published
Description
I wanted to design a mount that I could use in my 2014 RAM 1500 Big Horn. This uses the existing mounting holes on top of the dash where I would normally keep my sunglasses at. It does get direct sunlight and hot in vehicles, so I would recommend using a high temp and/or UV rated material when printing. PLA and PETG will sag with one good outing.
This specific ball mount was designed for the CarpodGo T3 Pro. You still have to use the mounting clamp and backplate that came with the screen, but its a tight fit and doesn't move around when clamped down.
One thing to be careful of is overtightening the screws when installing the bracket. Since i was using the existing screws and mounting holes, the walls can be a little thin and possibly fail/break when installing if you overtighten. Just get to the point of tightening to snug and no more. Broke a couple during prototyping when I overtightened.
Additional photos to come soon.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 954.1 KB
- Largest file
- 954.1 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-

