Skip to main content
F3D
Giá đỡ cho bộ dụng cụ Clorox ToiletWand 1

3 images

Đồ Gia Dụng

Giá đỡ cho bộ dụng cụ Clorox ToiletWand

By JohnS

Downloads
55
Likes
14
Views
417
Comments
1

Files 1 2.5 MB

  • clorox_toilet_wand_storage_insert_1766537252.stlSTL · 2.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#41046
Category
Đồ Gia Dụng
Published

Description

I didn't like how the pads weren't very constrained in the caddy and it made it a bit harder to load a new one on the wand, so I made this to fill in that extra space.

This is intended to be printed in vase mode with .9mm of bottom layers. I used a perimeter width of .7mm. You can do this with a .45 nozzle just fine but the one printed here was done with a .6 nozzle. Alternatively you could do 2 perimeters of .4 and that will just take longer.

I printed using .3 layers, .7 perimeter width at 60mm/s and it took about 2.5 hours and 102 g of PLA.

This has clearance features to avoid the clips that attach the handle holder to the caddy. Just make sure it is put in the right direction.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
2.5 MB
Largest file
2.5 MB

1 comment

See all