Skip to main content
F3D
Thiết bị Male Chastity Device - Mặt phẳng, có hỗ trợ Revers… 1

2 images

DIY

Thiết bị Male Chastity Device - Mặt phẳng, có hỗ trợ Reverse Pegging

By MA_1071100

Downloads
7
Views
113

Files 5 10.2 MB

  • cc2026.flat-Fillet021-FAR-F_1783843602.stlSTL · 2.3 MB
  • cc2026.flat-NU_1783843603.stlSTL · 2.7 MB
  • cc2026.flat-NL_1783843604.stlSTL · 1.7 MB
  • cc2026.flat-ThruPins_1783843605.stlSTL · 48.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a modification of the "male chastity device with Reverse Pegging", thing:6959897 This version features a flat front. It includes a sleeve that fits over the device, that can be used to hold a dildo, using a Vac-U-Lock attachment.

After printing, use a drop of superglue to glue the 2 pins to the ears on the device.  A two-piece ring fits behind the scrotum, with the curve facing backwards.  Slide the cage into place, and the pins will lock the two pieces of the ring together.  Use a small cylinder lock to lock the device closed.

Inside diameter of penis tube: 32 mm

Post-Printing: 

I recommend printing the pins at an angle, about 30 degrees or so, from the build plate. If you print them standing straight up, the break off easily. The inside of the cage has a groove to hold the ring of a PA piercing. It is sized for a ring that is 24 mm diameter, by 4 mm wide. I use a small length of chain that goes over the pins, thru the holes in the sides of the cage, and thru my PA ring, to prevent being able to pull out of the device.

The Reverse Pegging Attachment (RPA) should snap into place over the front of the device.  Use a hollow, 1/2" diamond drill bit to cut a hole in the base of your (or her) favorite dildo, then slide it over the Vac-U-lock attachment.  The Vac-U-lock attachment is scaled down a bit from the usual size, to make this easier.  But, be warned!  Once she finds out you can penetrate her with her favorite dildo, she may never unlock you!

Category: Other

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
10.2 MB
Largest file
3.5 MB

0 comments

See all