Bộ chặn bàn in (Buildplate Stop) cho Voron Trident

The Voron's Z endstop doubles as a great build plate stop. So why not have two?

Hardware:

• M3x16 SHCS (2 qty)

• M3 roll in t-nuts (2 qty)

• GT2 20T Timing Belt Pulley (5mm ID 6mm W) (Same part as from Z endstop)

• 5x30mm Shaft (Same part as from Z endstop)

Printed without supports. Same print settings and material as other Voron printer parts.

I included a STEP file to modify / remix.

Notes:

• Remove the zip ties from the Z Bed Rear part. This plate stop includes a channel to fit the cables in its place. Be careful not to pinch any wires when installing.

• I included a picture of how I installed the spacing for the M3 roll in t-nuts.

• Tighten pulley set screws to lock the shaft to your preferred height.