Giá đỡ DDU dưới màn hình cho Simracing

Inspired by https://makerworld.com/en/models/1293206-ddu-under-monitor-mount#profileId-1323808 but remodelled from ground up for:

1. A nut capture for M5 nuts

2. Shorted struts to get the DDU closer to the monitor

3. Flanged connection between strut and base for strength

Print Settings

I wanted this to be very strong so that I could torque down on the M8 bolt connecting the base to the wheel bracked. I printed in ABS with 6 wall loops, 8 Top and bottom shell layers, 60% infill. it tightened up nicely.

Fitting

Use good size washers to distribute the load over the bracket