
Thay quạt cho máy sấy filament Sovol SH02
- Downloads
- 4
- Likes
- 2
- Views
- 49
- Remixes
- 0
- Comments
- 0
Files 1 787.7 KB
- 5020_fan_duct_1783591442.stlSTL · 787.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #409920
- Category
- Máy In 3D
- Published
Description
IMPORTANT: To install new fan with a duct I needed to cut out a bit of plastic so the new duct could fit. Not difficult to do with flush cutters, but this voids your warranty. I needed to swap fan connectors because they were different. I can't recommend the fan that I bought myself due to lack of specs and poor seller communication, but I will share a link if you want to buy one anyway, because the fan isn't bad and the seller claims it uses maglev technology (but it could be both true or false with Chinese sellers). Does the job well. This mod was created to replace the stock fan and reduce noise.
Replace the stock 5025 fan with a custom 5020 blower fan. You can use any fan as long as it matches these parameters:
-
12 V
-
5020 blower fan
-
3-pin connector
-
Fan outlet 26 (26.3mm) × 20 mm
Since the AliExpress seller couldn't provide any specifications for the fan, I wasn't sure what to expect after the swap. In the end, it worked out well. The dryer reaches 70°C in about 30 minutes. The annoying squeaky noise is gone, replaced by a much smoother "whoosh."
Because I don't have any measurements from the stock fan, I recorded a timelapse so you can compare the heating performance with your own dryer if you're considering this upgrade.
Testing conditions:
-
Ambient temperature: 23°C
-
Cool draft in the room with good ventilation
-
No filament spools inside (to eliminate variables)
-
Top humidity vent open
-
Dryer placed on raised feet to prevent heat buildup underneath
Printed in ABS-CF.
0.16 layer height.
6 walls.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 787.7 KB
- Largest file
- 787.7 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-
New -

-

-

-


