Khay để tay vịn cho sofa Thomasville Gilroy

This model is fitted to the Thomasville Gilroy sofa/couch/lounger but will work with any armrest with an approximate width of 180mm (7"). Optimized to print on the Snapmaker U1.

If printing from the .stl, choose your preferred orientation and make a 0.4mm cut for a clean first layer. The .3mf file already has a cut. If you have a preference in the wood texture, use the .stl and modify as you see fit, otherwise use the .3mf. 

BumpMesh.com was used to apply wood texture. Support Stefan at cnckitchenus.store for this amazing tool. 

• Suggestions

  • 5mm auto brim for security

  • 3 wall loops for structural support

  • 10% infill is adequate

  • Adaptive Cubic infill pattern

  • Print in "C" orientation, especially on bed-slingers

• Notes:

  • PLA is fine for room temperature uses

  • No supports needed