
Khung Tiny Whoop - 1S - Tổng trọng lượng 31g
- Downloads
- 156
- Likes
- 29
- Views
- 1,277
- Remixes
- 0
- Comments
- 0
Files 2 1.5 MB
- body_guards_1783587436.stlSTL · 508.6 KB
- body_frame_1783587437.stlSTL · 1,022.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #409477
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
This whoop is based on Rygar1432's idea, but i designed the model from scratch.
FC is secured by the (included) rubber spacers on a separate nylon screws. This reduced a lot of noise coming from the motors into the FC and increased flight stability and time considerably.
Model is assembled with nylon standoffs, screws and nuts - https://www.banggood.com/180-PCS-M2-Nylon-Plastic-Screw-Screw-nutsInsulated-Column-Pillar-Set-For-FPV-RC-Drone-p-1314659.html
In place of battery holder i used jewelry string, it is flexible yet very hard to break - https://www.aliexpress.com/item/1005002233593961.html
PARTS:
*BetaFPV 0802 22000kv motors
(They make SE version now which is lighter, and 19500KV option is probably a better tradeoff in flight time/performance) *BetaFPV F4 AIO Flight controller
(Unfortunately they don't sell the FC i have anymore, but the new version should fit just fine, and has VTX already included) *BetaFPV M01 AIO Camera 5.8G VTX
(can be swapped with C01 FPV Micro Camera in combination with the new F4 AIO FC) *BetaFPV BT2.0 300mAh 1S 30C Battery *RKH 40mm 3 Blade Props Clear 1mm shaft
HARDWARE:
- nut - M2 : 4pcs
- screw - M2*6 : 8pcs
- Column - M2*6+6 : 4pcs
PRINT:
I printed the parts with 0.4 nozzle and 100% infill in ABS.
Layer height - 0.2mm
Line width - 0.4mm
Perimeters - 2
There are integrated supports under the frame screw holes, you can snap them out with small priers. No other supports needed.
Thanks
Category: DIY
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1.5 MB
- Largest file
- 1,022.8 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-

-


