Nhíp gắp Wafer - hỗ trợ lên đến 150mm

Our lab primarily works with 4'' wafers, so we only had a few pairs of large tweezers for bigger samples. This pair works well with wafers up to 150mm diameter. This is version 4, tested for about 2 months. The biggest challenge remains picking wafers up from a vaccuum chuck.

How to print

The lower jaw needs supports. Ideally use the 3mf where this is already set up.

How to assemble

1. Gather the parts, remove supports

2. Slide the upper jaw in place. Do not be afraid to use force.