Skip to main content
F3D
Máng Ăn Cho Chim Chống Sóc (Squirrel Proof Bird Feeder) 1

3 images

Đồ Gia Dụng

Máng Ăn Cho Chim Chống Sóc (Squirrel Proof Bird Feeder)

By jurassic73

Downloads
86
Likes
20
Views
1,911

Files 14 116.6 MB

  • bird_feeder_top_cap_wire_mount_1783074605.stlSTL · 8.7 MB
  • bird_feeder_top_cap_1783074607.stlSTL · 13.9 MB
  • bird_feeder_magnet_holder_1783074609.stlSTL · 397.2 KB
  • bird_feeder_bottom_insert_1783074611.stlSTL · 3.4 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

5/26/23
- redesigned perch to install with a single screw
- created template to mark hole to remove material with a dremel
- added an installation brace which makes building the tube easier
- added a chamfer to the top for easier tube install

5/6/23 - Update: These have worked great! I've had these in our yard now for six months. Lots of birds visit. Some seeds to get knocked out and on to the ground. This is fine in that I get ground feeder birds and also squirrels to clean them up.

This is a squirrel resistant bird feeder that uses both 3d printed parts, a piece of polycarbonate roofing from Home Depot and some hardware.

How is this squirrel resistant?  Jump to 5:20 in the video below or just click here. :)

Assembly Video (6:20)
 

Hardware used:
(5) 10mm M4 screws
(12) 10mm M3 screws
(2) 25mm M3 screws
(6) M3 nylock nuts
(6) 12x3mm rare earth magnets
PETG filament
Polycarbonate roofing piece

Using an 18" tall piece of polycarbonate, this feeder will hold roughly 4 lbs of black oil sunflower seed.

All parts print without supports. PETG or ASA would work nicely to deal with sun exposure. 

Default PETG slicer settings work except for two pieces. The small top cap wire mount piece and the three magnet holders got 5 perimeters.

Read more Show less

Print spec

Formats
3mfgcodestepstl
Model files
14
Total size
116.6 MB
Largest file
43.2 MB

0 comments

See all