Đèn ambient UFO (WLED)

This is a mode of UFO LED lamp with WLED  installed on EPS32

It's important to print "Beam" and "LED deflector" with WHITE PLA  in spiral vase mode with only one wall
To built  it you also need some M3 bolts and nuts, also a few hot inserts for M3 bolts

to make it light you need also  LED Strip
I used WS2812B RGB LED Light Strip Pixel Strips 5M 5V 5050 300 (60LED/m)
UFO Lamp has 4 LED segmetns:

• In base

• In beam (around pole)

• In UFO rould section

• Top section

  But it's up to you.

  You also need ESP32 controller . I used ESP32 Nodemcu Development Board for ESP32 NodeMCU Module USB C 2.4GHz WLAN WiFi Bluetooth CH340 Chip
  Then you need to install WLED from https://install.wled.me/

I attached "floating people" inside beam with termo glue

After printing i painted it with a spray paint 

To power it you need basic phone charger  or 5v over USB