Nắp che filter Panda Breath cho SnapMaker U1

When you install the Panda Breath in the SnapMaker U1, the bracket prevents you from sliding the lid open for the filter housing, making changing filters more difficult than necessary. I removed the filter cover, and designed a replacement that attaches with magnets to the metal body of the Panda Breath. 

Instructions:

Remove the four screws holding the filter cover to the Panda Breath. 

Magnetically attach this in its place, using four 10mmx2mm magnets. 

I printed mine in Tinmorry PETG-GF, which should hold up to the max 65 degree chamber temperature. Though you can certainly print it out of ABS or ASA for even better heat protection. 

A 40 minute print that uses just 13.5g filament and no supports if you print it face down.