Bộ phận thay thế giá đỡ thanh phơi quần áo

This replacement rod holder was designed upon request after one of these parts was missing from a newly received clothes drying rack.

I measured the original part that was provided to me and modeled this replacement to match it as closely as possible. The part was then printed and tested, and I received positive feedback that it fit correctly and worked as expected.

Depending on your printer, plastic, and slicer, the rod holes may come out slightly tighter than intended. To reduce the chance of needing a reprint, consider using a small positive Hole Expansion value in your slicer, for example, +0.15 mm.

If the rods are slightly loose, you can wrap a bit of electrical tape around the tube to increase its diameter and get a tighter fit.

I decided to share the model with the community in case it helps someone repair their own drying rack instead of throwing it away.

Feel free to adapt it to your needs.