Khay đựng bài Aeon's End (dành cho bài có bọc)

I wanted an insert that accommodates sleeved cards. I saw one insert, but it didn't fit my sleeves. I use Sleeve Kings 8810 (Card Game Sleeves).

I also wanted mid way card stops, so when you take some cards out they all don't slide and fall out of place...give them something to lean against.

Read the file names, print one of each except, 2 card trays (right side) and 3 component trays.

I also included some optional spacers, one to get the component trays to be flush with the top and one to fill in the small gap left next to the components. I print these at 5% infill, skip the bottom and top layers, use cross hatch and it's minimal filament and gets the job done.

Enjoy!

Category: 3D Printing