Khung đỡ cây mini dạng lắp ghép (Cho cây cà chua)

I created this as there were some design, but want one that could grow with the plant or use the same design with many plants. Also, allows for a lot less layers of printing.

I created 3 sizes of legs (one extra long as you have to bury it in the flower pot. Each have an extra 4 mm on each end that can be stuck into the levels. You can use the extension level to make 2-3 levels, or just print the top if you want a shorter one.

If you do widen the design to accommodate your exact sizing, I wouldn't mess with the length of the legs too much; they are sized to fit snug, but not tight at their current size. And they should stick in flush with the layers.

Category: 3D Printing