Ống hít từ tính cho mũi vít 4mm

Magtizer Sleeve for N52 Neodymium  5 x 1mm:

• Version  MagneticBit-4mm use 2 x N52( 5x1mm)

• Version MagneticBit2-4mm  use 4 x N52 ( 5x1mm) 

How to use:

1. Take the bit and place magnets on opposite sides and see if the magnetic fields are aligned, which will attract the screws.

2. In the bit sleeve, place the magnets in the order shown above. If you place the magnets in the wrong order, simply use the bit tip to remove the magnet from the sleeve.

3. Can be used as a Magnetic Sleeve or as a Magnetizer by inserting and removing it from the bit a few times.

How to print:

Print with circle towards the bed, or  it will get deformed and the magnet wont fit. Use Brim.