Miếng đệm nút ABXY cho Nintendo 2DS

Important notes:

• Each spacer should fit inside its respective button housing with enough play to not get snagged when the button is fully pressed up or down.

• Adjust the thickness of the spacers as needed.

Print notes:

• Slicer settings should prioritize precision. I would avoid fuzzy as it may prevent correct fit.

• Printed with 0.4mm nozzle.

• 0.16mm layer height.

• No adhesion brimming used.

• You may need to trim away any unevenness from the PLA settling on the print bed.