
Máy In 3D
Gioăng dẫn ống PTFE 5mm cho máy sấy nhựa
- Downloads
- 2
- Likes
- 0
- Views
- 36
- Remixes
- 0
- Comments
- 0
Files 1 17.1 KB
- grommet_1782445948.3mf3MF · 17.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #405265
- Category
- Máy In 3D
- Published
Description
Used to run 5mm tubing from an Eibos Cyclopes filament dryer to the Prusa XL side filament sensors. The grommet should be printed in TPU and will hold the PTFE tubing securely. As printed, the 5mm hole in the grommet was slightly undersized in my case, but a 5mm drill bit solved the problem in a few seconds.
I used a step drill like in the photo to open a couple of the holes in the Eibos Cyclopes lid to 8mm. Go VERY slow so you don't go too far with the step drill bit and have holes too large.
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 17.1 KB
- Largest file
- 17.1 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -
New -

-

-


