Skip to main content
F3D
Giá đỡ cọ lau Silicone cho máy in Ender 1

3 images

Máy In 3D

Giá đỡ cọ lau Silicone cho máy in Ender

By Ondrej

Downloads
1
Likes
1
Views
41

Files 1 1.1 MB

  • Silicone_Brush_Holder_1782382148.stlSTL · 1.1 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#404371
Category
Máy In 3D
Published

Description

Creality K2 plus silicone brush mounted on a 40x40 aluminium profile beside the bed, the part is made to sit beside the bed with a height of around 61mm height,

X axis for bed till 230, the wipe motion done under 231 to 250, this is under the assumption the bed height doesn't change frequently, for a different bed height you can simply extend the height in the slicer(uniform scaling off) but make sure the part is slightly higher than bed height, you can make the nozzle go higher to wipe in the start Gcode,

Here is the code I use, after bed levelling and before purge line

G92 E0 ; Reset Extruder

G1 Z3.3 F900 ; Lower nozzle down into brush (measure your nozzle clearence height over brush and set it here in place of Z3.3) 

G1 X231 F6000.0 ; Start at left edge of brush

G1 X249 F6000.0 ; Scrub right to the edge

G1 X231 F6000.0 ; Scrub left

G1 X249 F6000.0 ; Scrub right

G1 X231 F6000.0 ; Scrub left

G1 X249 F6000.0 ; Final scrub right

G1 X231 F6000.0 ; Final scrub left to exit the brush zone

G1 Z10.0 F900 ; Move Z Axis up high to clear the brush completely

Doesn't need support and print on its side for strength

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
1.1 MB
Largest file
1.1 MB

0 comments

See all