Skip to main content
F3D
Chibi Darth Vader — Mũ bảo hiểm nam châm (4 viên 2x6mm) 1

7 images

Đồ Chơi Khác

Chibi Darth Vader — Mũ bảo hiểm nam châm (4 viên 2x6mm)

By theStonefox

Downloads
3
Views
45

Files 1 13.6 MB

  • Mini_Vader_1782380098.3mf3MF · 13.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A cute, chibi-style Darth Vader figure with a removable helmet held in place by 4x 2x6mm magnets, pop it off, swap it, or just admire the clean fit. 

Designed with crisp panel lines, an fluffy cape, and a glossy black helmet finish that really sells the Sith aesthetic at this small scale.

Print details:

  • Two main parts: helmet + body

  • Helmet attaches via 4x 2x6mm magnets (press-fit, no glue needed). If you have none, use the included pins

  • Recommended: matte filament (I did with pla basic, and matte wouldve been a better choice here)

    Assembly:

  1. Glue magnets into the helmet sockets (mind polarity!)

  2. Glue matching magnets into the neck sockets on the body

  3. Test-fit before final glue cure, helmet should seat flush

A fun desk companion or gift for any Star Wars fan who appreciates a magnet

 ****************************
And no, this is not AI.

For a write up on why it is tagged as AI and why anything I sculpt going forward will be tagged as AI, you can visit the following model page:

 
Comments about AI on this model page will be ignored, so direct your concerns to the Plo Kloon model page, thanks

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
13.6 MB
Largest file
13.6 MB

0 comments

See all