Skip to main content
F3D
Chân đế và Đồ gá căn chỉnh cho bàn đá Granite 1

7 images

Đồ Gia Dụng

Chân đế và Đồ gá căn chỉnh cho bàn đá Granite

By JC_650_MT

Downloads
1
Likes
1
Views
48

Files 5 311.3 KB

  • Pentagon_Granite_Plate_Friction_Pads_v1_sliced_1782352266.3mf3MF · 46.4 KB
  • Pentagon_Granite_Plate_Friction_Pads_BOTH-Bracket_v1_sliced_1782352268.3mf3MF · 69.4 KB
  • TPU-Skid-PAD_v1_1782352269.stpSTP · 72.3 KB
  • Left_Bracket_1782352269.stpSTP · 89.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Granite Surface Plate Feet & Alignment Jigs

Printed the feet out of SainSmart TPU. You will most likely want four of these.

https://www.sainsmart.com/products/gt-3-flexible-tpu

Printed the Alignment Jigs out of Tough Pro PLA+, but any PLA should work.

https://www.3dfuel.com/products/pro-pla-filament-lulzbot-green-1-75mm

Used Clear Gorilla Glue to glue TPU feet to granite plate. Don't allow the PLA jigs to be glued to the plate. Remove them after gluing and placing TPU feet in place. I used blue painters tape to hold the TPU feet in place while glue was drying. I also put a smaller granite plate on the TPU feet to make sure they remained flat until the glue dried.

I cleaned the granite plate with Acetone many times until white towel was clean and no more residue or oils came out of the plate. Be cautious with Acetone. Wear proper personal protective equipment. Don't do this near open flame or heat source.

https://www.homedepot.com/p/Gorilla-1-75-oz-Clear-Glue-4500100/301050930

I also included the STEP files for those that want to edit or play with the design...

Read more Show less

Print spec

Formats
3mfstp
Model files
5
Total size
311.3 KB
Largest file
89.3 KB

0 comments

See all