Skip to main content
F3D
Bộ gá WobbleX phía sau cho Voron Trident-R1 1

3 images

Máy In 3D

Bộ gá WobbleX phía sau cho Voron Trident-R1

By Exerqtor_82339

Downloads
262
Likes
66
Views
2,608

Files 10 12.4 MB

  • WobbleX_3.1mm_TR8_Adapter_1782351179.stlSTL · 231.9 KB
  • WobbleX_3.1mm-MGN9H_Z_Carriage_Rear_2-hole-_IGUS_1782351180.stlSTL · 1.6 MB
  • WobbleX_3.1mm-MGN9H_Z_Carriage_Rear_3-hole-_Generic_1782351182.stlSTL · 1.7 MB
  • WobbleX_3.0mm_TR8_Adapter_1782351183.stlSTL · 232.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#403770
Category
Máy In 3D
Published

Description

Trident-R1 rear WobbleX carriers

CHANGELOG

  • 01.05.2023: Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.

  • 26.04.2023: Initial release.

Printing:

  • Default voron settings, correct orientation, no supports needed!

Bom:

  • 1x WobbleX WS8

  • Stock Voron Trident screws etc.

Description:

  • Since it's been a couple issues with the stock rear WobbleX Z carrier, which i have fixed for my MGN12H version i figured i could apply the same fixes to the MGN9H so that it's out there for those who need it. So here you go, enjoy!

  • It's also been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers & TR8 adapters.

10.5mm(old) vs 13mm(new)

- - -

In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!

Read more Show less

Print spec

Formats
stl
Model files
10
Total size
12.4 MB
Largest file
1.8 MB

0 comments

See all