Skip to main content
F3D
Bộ gá WobbleX phía trước cho Voron Trident-R1 1

1 image

Máy In 3D

Bộ gá WobbleX phía trước cho Voron Trident-R1

By Exerqtor_82339

Downloads
247
Likes
69
Views
2,157

Files 10 11.7 MB

  • WobbleX_3.1mm_TR8_Adapter_1782351159.stlSTL · 231.9 KB
  • WobbleX_3.1mm_z_carriage_right_1782351160.stlSTL · 1.5 MB
  • WobbleX_3.1mm_z_carriage_left_1782351161.stlSTL · 1.5 MB
  • WobbleX_3.0mm_TR8_Adapter_1782351163.stlSTL · 232.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Trident-R1 front WobbleX carriers

CHANGELOG

  • 01.05.2023: Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.

  • 26.04.2023: Variable pin sizes for WobbleX carriers, since it's been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers & TR8 adapters.

  • 23.04.2023: Initial release.

Printing:

  • Default voron settings, correct orientation, no supports needed!

Bom:

  • 2x WobbleX WS8

  • Stock Voron Trident screws etc.

Description:

Pictures:

10.5mm(old) vs 13mm(new)

- - -

In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!

Read more Show less

Print spec

Formats
stl
Model files
10
Total size
11.7 MB
Largest file
1.8 MB

0 comments

See all