Ốp công tắc đèn kiêm giá đỡ Sonoff Zigbee

I designed this last month because I needed a light switch cover to prevent accidentally switching off one of several rocker light switches that need to stay on permanently, and one of those is around the same area was where I wanted to mount my Sonoff Zigbee 3.0 USB Dongle Plus-E Gateway. It screws on top of the metal plate using the existing screws. The switch is locked in the "up" position, and the Sonoff slides in from the top.

I didn't print with supports, and I am a bit newer to designing 3D models but it came out well. There may be a small bit of brush to be cut away on the underside, that is not visible when the cover is installed on the plate. The front of the Zigbee gateway device is exposed as I was trying to conserve filament and just cared that it would fit.

I printed with white PLA on my Ender 3 V3 SE.