Máy phân phối pin hình con voi dễ thương

Easy to print two pieces battery dispenser.

Just apply some super glue on the marks and hold the pieces together while it dries, and its Done!

The pieces are flat from the bottom, but be sure to keep the piece upright while gluing to avoid any movement left when finished

Recommended settings:

-orientation: same as default, the flat side towards the buildplate

-material: pla, petg

-layer height: 0.2

-supports: NO

this is one member of my original "HomePals" collection that you can see here:

MEAFdesigns | Printables.com

________________________

If you like my designs and want to support me or sell physical prints, you can check out my patreon

https://www.patreon.com/meafdesigns

________________________