Đế lót ly kèm miếng đệm nút bần

Bring a touch of modern minimalism to your desk with this clean, functional coaster base. Designed to perfectly fit a square cork insert, it protects your surfaces from both heat and condensation while looking great.

Required non-printed parts:

• 1x Square cork insert: 10 x 10 cm (100 x 100 mm). ⚠ IMPORTANT NOTE: Please measure your specific cork insert before printing. Cork sizes can vary slightly depending on the manufacturer. You can easily scale the model up or down by 1-2% in your slicer to ensure a perfectly snug fit!

• 4x Round felt anti-slip pads for the bottom.

Print Settings:

• Material: PETG is highly recommended if you plan to put hot coffee or tea on it (PLA might warp under a hot mug).

• Infill: 15% is plenty.

• Supports: None required. Print flat on the build plate.

Enjoy your clean desk setup! If you print one, I'd love to see a make.