Nắp che nòng súng .22 (Cold Bore Cap) cho Vudoo, MPA, Bergara, CZ, Tika...

Hit more targets at your next match by preventing cold bore shift between stages:

When a .22 sits uncapped the moisture in the barrel can dry out causing the first round to go high, this shift can cost critical impacts.

The design uses 4x 4mm wide by 2mm high round magnets super glued in.

Assembly:

(1). place a small amount of super glue on a piece of paper or plastic

(2). pick up the magnet with a thin piece of metal like a #2 alen key

(3). dip one flat side of the magnet in the super glue

(4). using the piece of metal push the magnet into one of 4 holes on the cap

(5). repeat 3 more times

(6). cover the main hole in tape matching the color of the cap to prevent moisture escaping while not causing a catastrophic malfunction if accidentally shot

# I am not profiting from this but it is still my design please don't sell these caps and when sharing the file use this printables as the prusameters are all i am getting for the work.