Project Silverfish Eather-Flux Detector (mô hình full scale)

About this model

This model was designed in FreeCAD - FOSS (Free and Open-Source Software) 3D parametric modeler. Source file is available.

It is not 100% accurate in details, but proportions are true to original. It requires glue. You may choose either to paint the model or print in different colors.

Preview

Note

Front and top knobs can be rotated if not glued in too much. You should notice here yellow and peach parts that can be fit together to form a rotating joint. Be careful with glue.

There are two variants of the antenna. If you wish to print only one of them remember to disable parts of other on their plates (antenna_X_wire on plate 3, antenna_X_cap and second antenna_base on plate 4).

The antenna can be removed for ease of storage or to swap between variants. Here you can see white part (antenna base) should be held in place by friction (in cap part). Be careful to avoid gluing it.

Assembly

WIP