Shoe Stacker Pro - Giá đỡ giày thông minh, không cần support

This is a sturdy and robust shoe stacker. It holds one shoe above the other. There is plenty of room for even large shoes. The ones in the image are size

• UK 10 or EU 44/44.5. & 45 - men

• UK 8/8.5 or EU 42/43 - women

So all the shoes are large. They stay on easily and the wall is protected by the end stop.

For strength and to stop the upper level from sagging, I used 3 walls and 15% cubic infill.

Any filament should be fine. The red in the images is Sunlu PLA 2.0, I have some black in the same filament. If your shoes get wet a lot, maybe PETG might be a good choice.

Print on their side, no support needed.

The holes are for both rigidity and for air circulation, to help dry out the soles.

They are not a fast print somewhere in the 6 hours area, depending on machine.

If you want a larger version, please ask.

They fit nicely in places that are just one shoe wide. These are wide, 100mm, so stable and over most of the shoe width. Easy to use and simple to print.