
Giá Kẹp Phơi Lót Giày Cho Giàn Phơi Đồ
- Downloads
- 6
- Likes
- 2
- Views
- 72
- Remixes
- 0
- Comments
- 0
Files 4 1.7 MB
- shoe_insole_drying_holder_1781201285.scadSCAD · 5.4 KB
- shoe_insole_drying_holder.stl_1781201285.stlSTL · 1.6 MB
- README_DE_shoe_insole_drying_holder_1781201288.txtTXT · 6.4 KB
- README_ENG_shoe_insole_drying_holder_1781201290.txtTXT · 6.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #401527
- Category
- Đồ Gia Dụng
- Published
- License
- Creative Commons — Attribution
Description
Wet shoe insoles? Yeah, they always end up somewhere annoying.
I made this small holder so two insoles can dry properly on a clothes drying rack instead of lying on the heater, the floor, the windowsill or wherever they usually stay “just for a moment”.
The insoles are pushed in from below and held by the wavy clamp arms. The hook is made for typical drying rack rods around 8 mm.
The model prints flat and does not need supports.
I included README files in English and German.
The OpenSCAD file is also included, so you can adjust the holder if needed.
Depending on how thick your insoles are, you can either scale the model slightly in your slicer or adjust the OpenSCAD values directly. For the clamp width, change grip_gap. For the drying rack rod, adjust rod_diameter or rod_clearance.
Recommended print settings:
- Material: PLA / PLA+
- Layer Height: 0.20 mm
- Wall Line Count: 4
- Infill: 30-40 %
- Supports: No
- Build Plate Adhesion: Skirt
Print spec
- Formats
- scadstltxt
- Model files
- 4
- Total size
- 1.7 MB
- Largest file
- 1.6 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-

-
New

