Giá Đỡ Dây Nối Dài Thẻ SD (SD Card Extender Holder)

I like this SD card extender holder.  I have been using it on my CR6SE for several years, now.
It recently started falling off the display mount, and I noticed that the clip has splayed.

This remix adds a short (0.8mm) base to hold the full length of the clip parallel to the holder body.
I also extended the clip all the way to the back of the holder.  This maximizes the grip from the clip and allows rotating the clip onto the slotted end at the back, for printing without supports.

I have printed mine in PETG, simply because that was the filament I had loaded on the printer.
Hopefully, if the clip still manages to splay at the top, the bottom will have enough retention force to stop the extender from falling-off.   If not, I will be back, to remix this further...