Mô hình Star Wars Chain Code Disc

Chain Codes are a form of personal ID in Star Wars. There were different incarnations of Chain Codes, with these specific discs being issued by the Galactic Empire to all its citizen shortly after it was formed. They appeared in The Bad Batch.

This is a multi-colored model. It uses four filament swaps and does not need a MMU.

It uses four colors:

• Gray

• Red

• Black

• White

Using light and dark gray instead of white and gray would be more screen-accurate.

Dimensions

Length

Width

Height

68.8mm

56.2mm

3mm

Print Instructions

The model is split into a front and a back. Both can be printed at the same time. The back is just the front without the top layers.

The gray cut-outs on the sides are not centered. When glueing both parts together, make sure these cut-outs line up properly. If they do not, rotate one side by 180°.

Printed at 0.1mm layer height. (0.2mm works too, but the quality is noticably worse)

Ironing recommend.

This model uses filament swaps.

• start with gray

• swap to white at 0.9mm

• swap to red at 1.3mm

• swap to black at 1.5mm

• swap to gray at 1.7mm

The pre-sliced file contains all filament swaps.

If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#