Skip to main content
F3D
Giá đỡ camera Tapo C100 gắn cửa kính 1

5 images

Đồ Gia Dụng

Giá đỡ camera Tapo C100 gắn cửa kính

By jthomeo_1175944

Likes
1
Views
45

Files 1 828.9 KB

  • TpLink_Tapo_C100_Window_Mount_1780950731.3mf3MF · 828.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This mount requires you to cut the "leg" from the camera - see the photo. (Use the red-hot knife). 

I've printed in ASA, it has a light grip on the camera, but I'd still add a bit of a glue. If printing in PETG - scale the model down a tiny bit  (roughly 99.2% of the original size). 

P.S. One problem with this design is that night infra-red LEDs are shining directly into the glass and reflecting backwards, blocking any view at night. The "Fix" that worked for me was to open the camera, move the board with LEDs outside (via some soldered in extension) and physically located those night vision LEDs about 40cm away form the camera. (The plate with all the LEDs and mics - you only need to solder bottom two pins if  you don't need the mic)

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
828.9 KB
Largest file
828.9 KB

0 comments

See all