Dụng cụ lấy ve (Tick Remover) in 3D

A simple and effective 3D-printed tick removal tool designed to remove ticks safely and cleanly — without squeezing the body or risking the head breaking off, which are the most common mistakes when using regular tweezers.

Material: PLA or PETG (PETG recommended for outdoor kits — better UV, moisture, and heat resistance)

• Layer height: 0.12 or 0.16 mm

• Infill: 30%+

• Supports: none required

• Perimeters: 3+

How to use:

1. Slide the notch under the tick as close to the skin as possible.

2. Apply gentle upward tension — do not pull sharply.

3. Rotate 2–3 turns until the tick detaches cleanly.

4. Tilt the tool so the tick drops into the recess, then transfer it to a container for lab testing.

After removal: Disinfect the bite site. Do not discard the tick — take it to a laboratory for testing. Early testing allows treatment or prophylaxis to begin immediately without waiting for symptoms. Store the tick in the fridge until tested.

Important: never squeeze the tick's body or use heat — this increases the risk of infection.