Ốp chìa khóa cho xe CFMoto SXS

This key cover is modeled after the stock key that comes with the SXS.  I wanted a red cover that would be more visible if it was dropped or misplaced while outside so I made this and printed in red TPU.

I printed with manual snug grid supports under the cover and they were easily removed.  Just be careful the supports do not extend up inside the cover where the key fits or they may be difficult to get them out.  I also added supports right at the top of the opening for the key ring but you may be able to eliminate those and make a neater print.  The photo of my print doesn't have the text because I added it after I printed the one I needed.

I used 0.2 layer height with 4 wall loops, 3 top and 4 bottom layers which made a solid firm print.