Bộ sửa đổi phù hợp với Nerf AR-L

Muzzle parts are intended to minimize the blaster, as well as remove cartoonesque design elements. Other parts included make for a fun flywheel mod project! Refer to a Stryfe wiring diagram as needed if installing hobbyist components.

There are two options for the muzzle. One design is compatible with the stock flywheel assembly while one with compatible with the KuryKafe Modulus / Demolisher cages. Note: minor shell modification is required to make the cage fit. See second photograph.

Print muzzle delete as imported with supports enabled touching the build plate. Print front sight as imported, no supports required. See third photo. Note: muzzle delete is asymmetrical and must be orientated correctly when installing.

Switch mount: print as imported, no supports required. Mount the 21A switch to the switch plate with (2x) M3 coarse screws. Adhere switch plate to blaster using epoxy or superglue. Note: quite a bit of shell cutting is required. Removing the NC tab of the microswitch is also required. See fourth photograph.

Print battery tray as imported with supports touching the build plate. Expanded battery tray fits well with the following M3 thumb screw, which requires (1x) M3 bolt and M3 (1x) nylon lock nut. See fifth photo.

For rear minimization: simply remove and discard the rear stock outside shell and rear sight.

Print peg and sling as imported, no supports required. Install by inserting peg into left shell half. Insert (1x) M3 x 35mm bolt from right shell half and secure with (1x) M3 nut. See sixth photo.