Khóa cài dây đeo tối giản (10mm)

Specifications

• Compatible Strap Width: 10 mm (with 0.5 mm tolerance on each side)

• Strap Thickness: up to 1.8 mm

• Dimensions: Very small, lightweight, and low-profile

How to use

• Insert: Take one end of your ribbon/strap and push it from the bottom side up through Slot 1 (outer slot).

• Weave: Pass the ribbon over the first inner bar, and push it down through Slot 2 (middle slot).

• Lock: Pass it under the second inner bar, and push it up through Slot 3 (the last outer slot).

• Tighten: Pull the ribbon to adjust the size on your wrist. The wave geometry creates a natural friction lock. The harder you pull, the tighter it holds!

3D Print Settings

• Material: You can use PLA, but PETG is better because it is more durable.

• Supports: NO supports needed. Print flat side down.

• Infill: You should use strong infill, because it is a small part, and it will make it more resistant.

• Quality: 0.15 mm - 0.20 mm = Lower layer height makes the inner slot edges smoother so the fabric doesn't snag. But it is ok to use Prusa DRAFT settings