Bộ chuyển đổi Talon Magazine Adapter v2 cho Nerf Stryfe

Stryfe Talon Adapter v2

Description:
A new version of my Stryfe Talon Adapter, completely from scratch.

Changes from V1:
* A more crisp design that was actually done in Fusion, not in a slicer (yes, v1 was 100% done in a slicer)
* Improved geometry so that it is more rigid and stays more solid in the blaster.
* The top of the adapter that catches the magazine has been updated to better support hard reloads without tearing the filament.
* The latch has been redesigned to give a more positive grip.
* Improved magazine well beveling to reduce switching errors.
* Greatly tightened tolerances on the adapter to reduce jamming almost completely.
* Reduced tightness of the magazine in the adapter, making reloads easier.

Materials:
2x M3x6mm Pan Head Screw
1x Spring - I used a 0.5*6*15, 12 lap, but a pen spring works

Compatibility:
Tested with 3 different model Nerf Stryfe, 4 blasters in total, mainly with trash darts that I picked up off a field (on purpose to see how they would do). All my testing was done with PETG, but I would expect other materials would be fine, too. In the final version of the model, I got zero failures. Actual testing Stryfes, darts, and magazines are included in the pictures.

Magazine / Is it Compatible?
----------------------------------------------------------------------------------
Dart Zone 12rd Curved Talon Clone: Yes
Dart Zone 12rd Talon Clone: Yes
Dart Zone 15rd Talon Clone: Yes
Dart Zone 20rd Talon Clone: Yes
Worker 15rd Talon: Yes
X-Shot 15rd Talon Clone: Yes
Nerf 15rd Talon Clone: Yes

Instructions:

1. Add the latch to insert block and use a spring to help it hold in your talon magazine. Pictures are provided.
2. Slide the insert and latch into the tall side of the adapter body as shown in the pictures.
3. Secure insert block to the adapter with one or two M3x6mm screws.
4. Insert the Stryfe Talon Adapter v2 into the magwell of the blaster.
5. Slide a magazine into the adapter and try it out!