Ngàm gắn quạt 12032 cho K1C

[temperature_fan chamber_fan]
pin: PC0
cycle_time: 0.0100
hardware_pwm: false
max_power: 0.8 # Change a lower value if it's too loud.
shutdown_speed: 0
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PC5
min_temp: 0
max_temp: 70
control: pid
pid_Kp: 25.0 # Replace this to 25
pid_Ki: 5.0 # Replace this to 5
pid_Kd: 70.0 # Replace this to 70
target_temp: 0.0 # Set default to 0 so it won't run when not printing
max_speed: 1.0
min_speed: 0.0

  BOM

3×5×4 copper insert × 2  For fan (Top left & Bottom right)

M3×8mm SHCS × 1 For the mounting the fan on the duct

M3×10mm BHCS × 1 For mounting the fan at back panel

Warning: If you have a too (High power) fan, connect it dierectly on the (stock chamber-fan) port might fry your mainboard!!