Ốp bảo vệ cho Wahoo ELEMNT ROAM V3

I designed this simple case for my Wahoo ELEMNT Roam V3 to protect it a little bit. The buttons are not covered but it should provide at least some protection :)

I printed it in TPU 95A, but depending on the printer a softer Material might be even better. The model can be printed without supports, but even when using supports they can easily removed with some side cutters. I printed it laying flat on the bottom rim.

It might be a little finicky getting the device into the case but i had phone cases that were harder to put on and remove, so it should be fine :)