Khay đựng thức ăn cho chim tùy chỉnh (Parametric)

I needed another food tray for my budgies so that the one male in our flock of 4 wouldn't prevent his sister from eating. I am hoping a second food tray will be harder for him to control.

Safety note:

I don't know for certain which plastics are safe for birds. I suspect ABS would be OK, and PLA would be fine (depending on the dyes/pigments used).Use at your own (or your birds own) risk. Off the top of my head, the possible risks are:

• Chemical residue (toxicity)
• Off gassing
• plastic splinters and shards for the birds to pull on and swallow
  I am not a bird or plastic safety expert.

Print instructions

Category: Pets Instructions

The openscad source file has a bunch of parameters, to adjust the fit for the cage. I haven't tried to print it yet, and I may need to go back in and generate some support material for the perch bar and the back. I haven't decided what orientation to print this in just yet.

In order to make sure that there is really good layer-to-layer bonding, I will probably use 0.15mm or smaller layers, and lots of heat.

I think a light sanding and a thorough washing before use is a good plan. For ABS, I would also make sure it has a couple of days to off-gas after printing.