Mô hình Mantis Lord trong Hollow Knight

Please read before printing

Print Settings

You will need supports on the Head, Cloak, Torso, and both arms. I highly recommend adding brims to the legs, even adding a support to stabilize it further, but it can be done without.

Scaling

This model was intended to be a large statue, if you want to scale it even larger, be my guest. However, if you scale it down, you have no guarantee that there will be no sanding. The only exception is resin printing the model, which allows for tighter tolerances and will be easily shrinkable.

Assembly

Hot glue or other adhesive is heavily recommended.

1. Attach the left and right leg to the torso.

2. Attach both arms to the torso.

3. Put the cloak over the torso.

4. Fasten head to the top of the torso.

5. Attach model to the base.

If this gets enough likes and downloads I'll make the variant where a mantis lord is hooked onto a pillar, as shown in the photo below