Miếng chặn sửa cổng sạc cho OneWheel GT

Apparently the 3 pins on the charger port are only held in place by some white caulk, as many have experienced these pins can get pushed back such that the board doesn't charge, as they no longer mate with the charger plug.

This fix does not require any glue, but I would suggest a dab of construction adhesive to keep the wedge in place.

The "W" on this printed wedge marks the side that should face towards the Wires exiting the connector.

I would also suggest taking the time to scrape all the white caulk from around the pins, and inside the connector housing, then adding some new clear silicone around the 3 pins.

Print with PETG, 3 wall (for strength) no supports needed.

When you place the cover back on the battery box, this also helps hold the wedge in place.  The o-ring gasket would benefit from some o-ring/silicone grease, but do not attempt to fill the channel with it.