Skip to main content
F3D
Hộp đựng thuốc trượt đôi tiện lợi 1

5 images

Sức Khỏe

Hộp đựng thuốc trượt đôi tiện lợi

By ThomasLippert_538793

Downloads
4
Likes
1
Views
69

Files 8 5.7 MB

  • Pillulier-Case_1779946150.3mf3MF · 49.5 KB
  • Pillulier-Insert_Demi_NoLetter_1779946151.3mf3MF · 100.4 KB
  • Pillulier-Insert_Demi_M_1779946152.3mf3MF · 211.4 KB
  • Pillulier-Insert_Demi_N_1779946153.3mf3MF · 199.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A sliding pill box with two independent slider, that snap at every 7 slot. 

Sliding mechanism:

Note the first push to open it is always harder than for each slide after. (Cause there two notch to push at first).
I design it with the objective of not open itself after a drop of 1-2 meter height.

The sliding is tight at first, but it get way better after playing a bit (~20 slide).

If your print isn't perfect, you can scrap a bit of excess, especially on the notch part on the sliders or opposed to it (you can notice the print line flatten with friction with the case, that's where scraping will be useful).

If you need to get easier sliding, you can reduce size of the slider on X and Z about 1% or more, or increase the size of the case. That should do the trick.

Marking:

The letter M, N, E, B, S, is for Morning, Noon, Evening, ...  You have the CAD for more letter.

I didn't make letter for the days on each slot, cause it's intended to be use with both side i didn't know in which order to put the letter, I find it kinda confusing with letter of the day. But again if you prefer you have the CAD.

For the outside design, I share the blank file, you can add features with tool like BumpMesh.
The cat was made with an image into svg on inkscape and then into freecad after that I use bumpmesh around it for the wood like aspect.

Tips for print:

Case should be print along Z axis to avoid support.
Slider flat on bed with support needed on the bumping mechanism, I recommend the painted support feature.

CAD Model:

CAD model should be parametric in the varSet param for Width > 20mm and Length > 75mm.
For length < 150mm your finger might not reach inside the slot, and the notch may be to hard to flex.
For length > 150mm the notch may be increasingly easier to flex.

Read more Show less

Print spec

Formats
3mffcstd
Model files
8
Total size
5.7 MB
Largest file
4.5 MB

0 comments

See all