Chân máy đánh chữ Tip-Tip (Tip-Tip Typewriter Feet)

Replacement feet for the Tip-Tip typewriter (Mignon-alike). Assumes you have original hardware. Hardware will poke through to the back of the case to prevent the rubber from turning. If you don't want that either reuse the felt pad that separated the original feet from the case or use a small piece of padding to accomplish that same task. These feet are slightly taller than the original to keep the amount of that poke-through down to much less prominence.

I printed mine on an Elegoo Saturn with 80 ShoreA "SuperFlex" resin. It actually worked better to print it flat to the build plate than angled. Of course YMMV