Liberator từ Blakes 7

Back to the 70's with a simple model of the Liberator from Blakes 7. The model is a bit of a work in progress and I intend to further detail in time

Its sized to enable printing on a Prusa Mk4. Limiting factor is the strut height and width on the printer bed. I'd like to make it bigger but not sure how I'd make a relatively thin load bearing structure in more than two pieces - I guess I could use a stand and make the struts non-load bearing if needed.

I've taken a few liberties with the design but I'm sure Avon would be cool with that.

Apologies for originally mislabelling it - no AI was involved in this design  although obviously access to Orac would have been helpful.