
Chốt giữ giá đỡ sau cho xe Opel Meriva
- Downloads
- 56
- Likes
- 12
- Views
- 589
- Remixes
- 0
- Comments
- 2
Files 2 286.6 KB
- MerivaBackShelfPin_v10_1765637423.stepSTEP · 81.3 KB
- MerivaBackShelfPin_v10_1765637424.3mf3MF · 205.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #38537
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
Story/Design:
Pins that were holding the back shelf of the meriva got broken, so I designed them to be push-in pins, because it was hard to get to the other side of the plastic. I also wanted it to be locked in place as people who are using this car are popping the shelf with quite a bit of force.
Unfortunately, when I came to take some measurements of the pin hole there was no original pin left, since I don't know how it looks, I'm not gonna compare them side by side.
Instructions:
To lock the pin in place Im using some weak zip-tie. I use a weak one because it snaps after locking in place so there is no zip-tie left behind the plastic wall. However, if you print it with PLA, zip-tie might snap before locking, and you will be left without a locking piece (happened to me once)!
Printing:
Since you need to squish it a little before inserting, and then it needs to expand when in its place, I strongly suggest printing it with PETG or something similarly flexible. I printed it horizontally and got good results.
Let me know what you think!
Print spec
- Formats
- 3mfstep
- Model files
- 2
- Total size
- 286.6 KB
- Largest file
- 205.3 KB
2 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


