Bao đựng bấm móng tay

This is my first “non” Tinkercad model. I used Onshape to create this relative easy model of a nail clipper sleeve. It's called v2 because of my own iterations to get it right for my own clipper.

To print it without supports it needs to be positioned upright on the small flat backside. I used a brim for stability which worked fine for each of my iterations.

Again, this sleeve is designed to fit my 8cm long clipper but I expect it will work for many clippers of about the same size. There is a small bump in the rear of the sleeve that is supposed to “fall” into the cut-out on the back of the clipper to prevent the sleeve of sliding of too easily.

I created a reinforced version as this one is prone to breaking: