Guide cho DREMEL Moto Saw

Guide for DREMEL Moto Saw

This is a guide for the DREMEL Moto Saw. It's adjustable from 0° to 45° degrees.

I made two versions:

• The STANDARD Mainbody has a rail width of 4.80mm (this should slide properly, but has some clearance...)

• The THIGHT Mainbody has a rail width of 4.90mm ( I wanted to eliminate clearance fully, but I had to grind the rails slightly to get a proper slide with no clearance. I also added a bit of lubricant.)

There are also two versions for the bar:

• Bar#1 has slots at 0° and 45° to prevent damage

• Bar#2 has the possibility to put in a sacrificial insert for other angles than 0° or 45° degrees (you can print it or adapt a piece of wood...)

Hardware you need:

• 1x  M4x25 Screw (Bar)

• 1x  M4x20 Hex Screw (Screwhead)

• 1x  M4 Nut Bolt (Slider)

• 1x  M4 Lock Nut Bolt (Bar)

Print recommendation:

Material: PETG/PLA

Wall perimeters: 4

Infill: 15-20%

Supports: None

Brim: Only for screwhead

Color printing:

Mainbody: Make a color change after 1st Layer

Bars: Make a color change at 1.20mm

Happy tinkering!