
Nắp che trên Snapmaker U1 (Top Cover tháo rời)
- Downloads
- 3
- Likes
- 1
- Views
- 54
- Remixes
- 0
- Comments
- 0
Files 1 269.6 KB
- SnapmakerU1TopCoverByMakermaksSnorca_1778678228.3mf3MF · 269.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #383820
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
-
This design is a detachable top cover for the Snapmaker U1. The lid is detachable too for easy access down the top.
-
The parts all print on the U1. The .3mf file has all the plates with settings for support in a few places.
-
Use 3mm clear acrylic sheets for the panels. A sheet of 500mm x 750mm is large enough for the side panels. The lid takes an additional 500mm x 750mm sheet. Cut the panel a little (4mm) undersize in each direction to fit in the grooves of the parts.
-
Gluing the parts to the panels is what holds this thing together. Three dabs of epoxy distributed along each groove will be plenty strong. You can ruff up the panels with sandpaper where the epoxy goes for better adhesion.
-
Use 2x8mm EPDM glass tape to seal at the bottom between the cover and the U1 and at the top between the cover and the lid. 4m should be enough. The cover and lid are tight but remains detachable this way.
-
Print in PETG or other heat resistant filament, not PLA. A 1kg roll should be enough.
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 269.6 KB
- Largest file
- 269.6 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -
New -

-

-


